1. Turn on the power switch and check whether the single-twist machine equipment is operating normally.
2. Clarify whether the model specifications of the single-twist machine parts are used appropriately.
3. Pull the core wires from the tension frame guide wheel of the single twisting machine down to the entrance and exit of the twisting die, strip off the outer PVC, twist the core wires together and reconnect them, pull the core wires of the power line through the die, and pull the traction rope onto the rubber roller.
4. Set the basic parameters according to the specified twist pitch and twist direction.
5. Set the total length of the stranded wire and the length of the stranded wire to be pre-staged according to the order information requirements.
6. Operational machinery and equipment must be inspected and confirmed to be qualified before being put into mechanical use for the first time.
7. Even when the machinery and equipment are operating normally, regular inspections should still be performed.
8. When lowering the shaft, wrap the twisted core wires with a clean service film, attach a label, and prevent them from waiting for the next use.
9. When wrapping aluminum foil, select the appropriate specifications and twist direction according to the building project's plan, install them uniformly on the tape opening, and after adjusting to the proper angle, ensure that the foil surface with conductivity can touch the core wire.
10. Ensure that the speed adjustment of the aluminum foil tape is consistent with the twisted core wire drive.
2. Clarify whether the model specifications of the single-twist machine parts are used appropriately.
3. Pull the core wires from the tension frame guide wheel of the single twisting machine down to the entrance and exit of the twisting die, strip off the outer PVC, twist the core wires together and reconnect them, pull the core wires of the power line through the die, and pull the traction rope onto the rubber roller.
4. Set the basic parameters according to the specified twist pitch and twist direction.
5. Set the total length of the stranded wire and the length of the stranded wire to be pre-staged according to the order information requirements.
6. Operational machinery and equipment must be inspected and confirmed to be qualified before being put into mechanical use for the first time.
7. Even when the machinery and equipment are operating normally, regular inspections should still be performed.
8. When lowering the shaft, wrap the twisted core wires with a clean service film, attach a label, and prevent them from waiting for the next use.
9. When wrapping aluminum foil, select the appropriate specifications and twist direction according to the building project's plan, install them uniformly on the tape opening, and after adjusting to the proper angle, ensure that the foil surface with conductivity can touch the core wire.
10. Ensure that the speed adjustment of the aluminum foil tape is consistent with the twisted core wire drive.